9V POWER JACK
Attach the output plug from the included power supply to the 9V power jack. WOTM draws 40mA at 9VDC on a center-negative plug. Do not exceed 10.5VDC on the power jack.
COLOR KNOB
Sets the intensity of the flanger effect. As you turn COLOR clockwise, the effect becomes more pronounced, producing that classic whoosh effect flangers are famous for.
RANGE KNOB
Allows you to set the lower limit of the flanger sweep. A fully counterclockwise setting, where the lower limit is just below the higher limit, creates a narrow sweep effect. As you turn RANGE clockwise the flanger sweeps down further into the bass region.
RATE KNOB
Controls the speed of flanger modulation. As you turn RATE clockwise, the flanger’s speed increases. Higher settings of RATE give the effect a sound like vibrato.
FILTER MATRIX SWITCH
When this switch is set to the right position, labeled FILTER MATRIX, the modulation waveform is disconnected from the flanger circuit, freezing the flanger and creating a matrix of filters. Turn the RANGE knob to change the filters’ position and use COLOR to adjust the depth of filtering. The RATE knob has no effect when set to FILTER MATRIX mode. Proper manipulation of the RANGE and COLOR knobs will enable you to simulate the sound of chimes being played in unison with your instrument, as well as many other effects.
INPUT JACK
Audio input to WOTM.
FLANGED OUT JACK
Main audio output from WOTM. All flanging and modulation effects will emanate from this jack.
DRY OUT JACK
Secondary audio output from WOTM. DRY OUT is directly connected to the INPUT jack in all modes.
FOOTSWITCH & STATUS LED
Use the footswitch to switch between bypass and effect mode. The LED is off when WOTM is in true bypass mode. When WOTM is active, the LED is lit.